If wireless is desired, find the SSID (Network Name) and Wireless Password printed on the label on the bottom of the router. Step 7: Connect your computer to the router (wired connection) or connect wirelessly. Note: If the 2.4G LED and 5G LED are off, please press the WPS/Wi-FI On/Off button for 2 seconds and check the LEDs again moments later. Step 6: Verify that the LEDs for Power, 2.4G Wireless, 5G Wireless and Internet (located on the front of the router) are on and solid before continuing with the configuration. Step 5: Plug the supplied power adapter into the Power jack, and then press the On/Off button to turn on the router and wait for 1 minute. (Replace the battery if you removed it previously.) Step 4: Turn on your modem and wait for 2 minutes. Step 3: Use another Ethernet cable to connect your computer to one of the Ethernet ports (yellow) labeled 1/2/3/4 on your router. Step 2: Use an Ethernet cable to connect the Internet (blue) port of the router to the modem’s LAN port.

If the modem has a backup battery, please remove it too. Step 1: Power off your modem and disconnect your existing router (if you have one). Follow the steps below, or review the Quick Install Guide for details.Before installing the router, make sure you are able to connect to the Internet using a computer or other device.Keep at least 2 inches (5 cm) of clear space around the router. Make sure the router is placed in a well-ventilated location far from any heater or heating vent.

Tp link ac1200 troubleshooting